No products
Prices are tax included
8 Zone 230v Underfloor Heating Wiring Centre
EPH Myson Honeywell 2 Port Actuator: Drayton 2 Port Actuator DT1P
4 Zone 230v Underfloor Heating Wiring Centre UH4
The Heatmiser neoStat v3 in sapphire black is a 230V programmable thermostat with illuminated soft touch keys and a proximity sensor. Upgraded hardware gives a stronger mesh signal and better range than the v2. Requires a neoHub Gen 2 or newer for smart control — not compatible with the original Gen 1 hub.
The Heatmiser UH8-RF v2 is an 8 zone wireless wiring centre for water underfloor heating, mounted beside the manifold. It switches zone actuators, UFH pump and valve on demand, with a volt free boiler output and a dedicated hot water output. Works with Heatmiser RF thermostats including the neoAir v3.
EPH CP4-HW-OT – OpenTherm® Programmable Cylinder Thermostat
8 Zone 12v Underfloor Heating Wiring Centre
The EPH GW04 is a dual band WiFi gateway that connects EPH wireless heating controls to the Ember app, giving control of your heating from anywhere. It works on both 2.4GHz and 5GHz networks and pairs up to four R_7-RFV2 programmers. Check your programmer model — the GW04 is not interchangeable with the GW01 or GW03.
The Heatmiser Thimble Sensor is a discreet white remote air temperature sensor, compatible with all Heatmiser thermostats that accept remote sensors. Its small thimble enclosure surface mounts on a backplate or ceiling tile in the natural airflow of the room, letting you measure temperature accurately without a thermostat on the wall. 2 Meters Lenght
The Heatmiser Boost v2 is a surface mount repeater for the Neo and RF systems, extending communication between RF thermostats, wiring centres, neoStats, neoAir v3 and the neoHub Gen 2. Hard wired for reliable performance, it is the fix for dropped signals in larger properties or where thermostats sit far from the hub.
Heatmiser Multi Mode Programmable Touchscreen Room Thermostat Carbon
The Heatmiser Wireless Air Sensor measures room temperature remotely for the Touch V2, Edge and Neo systems. At just 40x40x11mm it mounts discreetly on any flat surface, and multiple sensors can be paired to one zone for an averaged reading.
The Heatmiser neoStat v3 in platinum silver is a 230V programmable thermostat with illuminated soft touch keys and a proximity sensor. Upgraded hardware gives a stronger mesh signal and better range than the v2. Requires a neoHub Gen 2 or newer for smart control — not compatible with the original Gen 1 hub.
HEATMISER EDGE-HC MULTIMODE FAN COIL THERMOSTAT WITH MODBUS COMMUNICATION
Viewed products
Track your order
Insert your tracking number :